标题: 麻烦各位翻译一下 [打印本页] 作者: 刻家人 时间: 2009-1-24 20:52 标题: 麻烦各位翻译一下 USING YOUR SWITCH
Powering Up the Systems
Once all cables have been connected, power up your CPUs that are attached
to the Switch. All computers can be powered on simultaneously. The Switch
emulates a mouse and keyboard on each port and will allow your computer to
boot normally. Your Switch should now be ready for use.
You can select which computer to operate by either the front-panel push button
located on the top of the Switch or through hot key commands. Note that it
will take 1-2 seconds for the video to display after switching. This is due to
the refresh of the video signal. A re-synchronization of the mouse and keyboard
signal also takes place. This is normal operation and ensures that proper
synchronization is established.
You can conveniently change ports on the Switch through a keyboard command
sequence using the “SCROLL LOCK” key and up and down arrow keys. To send
commands to the Switch, press the “SCROLL LOCK” key twice within two seconds.
You will hear a beep for confirmation. Then you can press the up or down arrow
keys to switch between ports.
Switch to next active port, Switch to previous active port,
up arrow down arrow
14
P74711ea_F1DJ10x_man.indd 14 13/4/06 6:10:28 pm
You can switch directly to any port by entering the Switch port number you
wish to use. For example, if you press “SCROLL LOCK”, “SCROLL LOCK”, “2”, the
computer on port 2 will be selected.
+ +
Switch to Port 2—(02)
AutoScan Mode
In AutoScan mode, the Switch remains on one port for eight seconds before
switching to the next. This time interval cannot be changed.
To enable AutoScan mode, press “SCROLL LOCK”, “SCROLL LOCK”, “S”.
Note: There is no mouse or keyboard control in this mode by design, in order
to prevent errors. If it were enabled, the user could move the mouse or use the
keyboard while the KVM Switch is switching to the next port. This could interrupt
communication between the computer and Switch that might cause erratic mouse
movement, or result in errant display of characters when using the keyboard.
To disable AutoScan mode, press the space bar.
Switch to next active port, Switch to previous active port,
up arrow down arrow
Q: What operating system does the Switch support?
A: The Switch will support any operating system that runs on a PS/2 platform.
It will also work with Sun and Mac operating systems using the appropriate
adapters (Belkin OmniView Sun Adapter F1D082, OmniView Mac Adapter
F1D080). Operating systems include, but are not limited to, DOS, Windows 3.x,
95, 98, 2000, Me, NT, XP, Linux, and Novell NetWare 4.x/5.x.
Q: Does the Switch function with the Microsoft IntelliMouse?
A: Yes, the Switch will function with Microsoft, Logitech, Kensington, as well as
with all Belkin mice. The Switch will support only two mouse buttons. Please
contact Belkin Technical Support for any compatibility questions you may have.
Q: How does the Switch allow the user to toggle between ports?
A: The Switch supports two methods of port selection. The user can choose
computers using specially designated hot keys from the keyboard, or by
pressing the front-panel push button.
Q: How far can the user be from the Switch?
A: When using PS/2 connections, the Switch can be up to 25 feet away from
your computer. If your computer needs to be more than 25 feet from the KVM
Switch, you can use the Belkin CAT5 Extender (part number F1D084) to extend
the operation distance of your PS/2 keyboard, PS/2 mouse, and monitor up to
500 feet away using standard CAT5 UTP cable.
